Parts

NEW LIGHT YOKE 1 1/2 in. shaft hole

NEW LIGHT YOKE 1 1/2" shaft hole

Quick Disconnect Pin for PTO QDK1

Quick Disconnect Pin for the older SQUARE PTO's This pin sticks out the side through the smaller hole and has a keeper clip on the outside. Approx 3/8" small end and 1/2" larger end Approx. 3 1/4" in length  

HEAVY DUTY BLADE 1/2" X 3 1/2" X 24 1/2" WITH 2" OFFSET (Right blade)

***Note: These were used on the Boss 10 model 10 foot cutter and some 5 foot cutters Verify length before ordering HEAVY DUTY BLADE 1/2" X 3 1/2" X 24 1/2" WITH 2" OFFSET Right Blade 22 1/2" center of hole to end, 24 1/2" overall length **Blades sold...

HEAVY DUTY BLADE 1/2" X 3 1/2" X 24 1/2" WITH 2" OFFSET (Left Blade)

***Note: These were used on the Boss 10 and some other 10 foot cutters Verify length before ordering 1/2" X 3 1/2" X 24 1/2" WITH 2" OFFSET (22 1/2" center of hole to end, 24 1/2" overall length) Left Blade   **Blades sold individually.  If...

Metal Shim 60MM x 50MM x .3MM

Metal Shim 60MMX50MMX.3MM

Metal Shim 60MM x 50MM x .5MM

Metal Shim60mm x 50mm x .5mm

Auger Blade 2 hole

Auger Blade 2 hole 1" centered    

Gearbox 6 Spline Input 15 Output

Input shaft: 1-3/8 in. 6 Spline shaftGear ratio: 1:1.46Output shaft: 2 in. diameter, 15 SplineMounting Pattern:(4) 3/4" holes8" bolt pattern5.5" clearance for output cap

FRONT RB72 CHAIN GUARD ASSEMBLY

FRONT RB72 CHAIN GUARD ASSEMBLY

Large Double Roller Bearing for RTC

2" I.D. X 4 3/8 O.D. x 1 1/16 thick used on RTS-50

GEARBOX shear pin / 15 spline output

Gearbox used on some of the 6, 7, 8 and 10 foot cutters. Smooth Input Shaft with 15 Spline Output Shaft Longer output shaft (approx 6") Measure accross the output shaft, for the bolt circle. It should be approx. 8”

Shank / Tine (old style w/holes)

shank old style w/holes