Gearboxes

Gearbox 6 Spline Input 15 Output

Input shaft: 1-3/8 in. 6 Spline shaftGear ratio: 1:1.46Output shaft: 2 in. diameter, 15 SplineMounting Pattern:(4) 3/4" holes8" bolt pattern5.5" clearance for output cap

GEARBOX shear pin / 15 spline output

Gearbox used on some of the 6, 7, 8 and 10 foot cutters. Smooth Input Shaft with 15 Spline Output Shaft Longer output shaft (approx 6") Measure accross the output shaft, for the bolt circle. It should be approx. 8”

GEARBOX CENTER T-BOX 6 SPLINE

GEARBOX CENTER T-BOX 6 Spline shafts 1-3/8"-6 Splines Overall length 14" (shaft to shaft) Mounting bolt pattern 5"x 3.25" Gear ratio: 1:1 SU Ratio  

Side Gearbox 12 Spline Input

Side Gearbox 12 Spline **used on 10 foot cutters 100HP

GEARBOX TILLER (CHEETAH)

GEARBOX TILLER (CHEETAH) 1.917:1 ratio 4.5" x 4.5" bolt distance hex thru shaft RTC and RTR models only  **will not work on RT models.

TILLER HUB ASSEMBLY- IDLE END

ROTARY TILLER OUTBOARD HUB ASSEMBLY IDLE END

GEARBOX FOR PHD75

GEARBOX FOR PHD75 3.18:1 ratio

GEARBOX FOR PHD45

GEARBOX FOR PHD45

Gearbox for PHD25

Gearbox for PHD25

1" FLAT WASHER

1" HEAT TREATED FLAT WASHER

1" - 14 SLOTTED NUT

1" - 14 FINE THREAD SLOTTED NUT used with washer and cotter pin to attach stump jumper to gearbox on all of Howse cutters

1/2" PIPE PLUG - 11NC

1/2" PIPE PLUG - 11NC