Shop Parts

BEARING CUP

BEARING CUP    

BEARING CONE 75-448

2.84 OD X 1" thick  

WASHER FORK ZINC PLATE 1 1/2"

WASHER FORK ZINC PLATE 1 1/2"

CAT I RIGHT A-FRAME (TILLER, DRG, BOX BLADE)-1672808941

****fits all models, but older models will have to have a hole drilled in order to be mounted  lift pin goes thru a-frame  

CAT I LEFT A-FRAME (TILLER, DRG, BOX BLADE)-1672808939

distance right to left on the braces that the A-frame fastens to is 24 3/8"    lift pin goes thru a-frame CAT 1 ****fits all models, but older models will have to have a hole drilled in order to be mounted

#6 SERIES 12 SPLINE PTO D.S. W/CV JOINT

73" CLOSED 6 SPLINE (540) QD TRACTOR END 12 SPLINE CLUTCH W/CV JOINT   IF THE GEARBOX HAS THE 1" SMOOTH TIP ON THE END OF THE CENTER SHAFT, IT WILL HAVE TO BE CUT OFF. ALSO, THE SPLINES ON THE SHAFT MAY NEED TO BE SHARPENED, OR SMOOTHED OUT FOR THE...

RC DRIVESHAFT, 8, 58", 1000RPM

20 SPLINE ON EACH END RC DRIVESHAFT, 8, 58", QD-CV 20 SPLINE FEMALE, TL MALE-20 SPLINE 1 3/4"

1" x 8" BOLT NC GR5 HHCS ZINC

1" x 8" BOLT NC GR5 HHCS ZINC

7' REAR 1/2 CHAIN GUARD

7' REAR 1/2 CHAIN GUARD 14 3/4" bolt hole distance   **Due to high demand, please call for availability and shipping quote

600 series blades 1/2" x 3 1/2" x 30 3/4" 2" offset

600 series blades 1/2" x 3 1/2" x 30 3/4" 2" offset Overall length of blade is 30 3/4" **Blades sold individually.  If needing a set please order qty of 2

#4 Series Driveline 53"

#4 Series Driveline - collapsed length 53"

Quick Disconnect Pin for PTO

Approx 2 1/4 " long and .55 OR 14MM in diameter Quick Disconnect Pin for PTO ***This pin is held in by a roll pin and nothing stuck outside of the yoke.  The yoke will have a hole that doesn’t go all the way through the yoke